$95 SHIPPING

The PM15 Planer/Molder from Powermatic is loaded with features that make it a standout. A large 5HP motor supports a 15" wide planing capacity and enough power to run double knife sets for molding. The stand is fully enclosed and equipped with integral casters for shop mobility. Two feed speeds, 10 and 20 FPM, allow you to operate quickly for maximum stock removal, or more slowly to yield a fine milled finish on decorative moldings. The hinged top has a 4" dust collection port, and opens to expose the cutterhead, allowing for fast and easy tooling changes. This machine will use either single molding knives or 3 knife sets.

Brochure
Manual

Strong 5HP motor powers through big jobs
15" planing capacity is wide enough to run double molding knife sets
Large cast iron table is supported by four lead screws and has chain and sprocket height control for precise depth of cut positioning
Feed rollers and cutterhead supported by sturdy cast iron head assembly
Runs two feed speeds, providing maximum stock removal at the higher speed and a fine milled finish for decorative moldings at the lower speed
Uses single or three-piece molding knives, providing a wide selection of profiles
Large handwheel and easy-to-read inch/metric scale for fast set-up Hinged top for fast, easy tooling changes
Fully enclosed base cabinet with integral casters provides complete mobility
Urethane infeed and outfeed rollers
Includes dust hood with 4" chute

Standard Equipment
Motor with magnetic controls
Four casters
Dust hood
Knife set
Knife gauge